OHAUS MC2000 Bedienungsanleitung Seite 6

EN-4
3.3 Operation Modes
3.3.1 How to Perform a Test
1. Press button and the instrument starts self-check.
2. Press and
sample to be measured (refer to section 8, category code list, for details),
press button to enter measurement mode.
3. Fill the sample grain into the empty container.
4. Remove the funnel from container.
5. Remove excess grain with cover.
6. Place the container over the moisture analyzer and press the release
button on the container.
7. Without pressing any key, the analyzer will automatically start the
measurement and the moisture value will be displayed after about 5
seconds.
Fill the sample grain
(use full container)
Place the container
over the analyzer
MC2000 Moisture Analyzer Series
buttons to choose the category code of the respective
Remove the funnel
Press the release button
Remove excess grain
with cover
Show results automatically