Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INTRODUCTION
Thank you for deciding to purchase the Metal Sock & Stocking Aid from Aidapt. The
Metal Sock & Stocking Aid is manufactured from the finest materials and
components available. When used correctly it is designed to give many years of
reliable trouble-free service.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments
as this may damage the surface of the product.
Check the product for any visible damage If you see any damage or suspect a fault,
do not use your product, but contact your supplier for support.
INTENDED USE
The Metal Sock & Stocking Aid makes putting on socks, tights (pantyhose) or
stockings easy.
INSTRUCTIONS FOR USE
Using the Metal Sock & Stocking Aid is simple:
Stretch the sock or stocking inside out over the shorter, central arms of the
•
Metal Sock & Stocking Aid.
Push the foot into the toe of the sock/stocking.
•
Using the two metal handles, pull the Metal Sock & Stocking Aid up the
•
calf, this will pull the sock or stocking up at the same time.
When the sock/stocking is fully extended and fitted to the calf, slightly lift
•
the Metal Sock & Stocking Aid to release it from the sock/stocking.
You can then remove your leg from the Metal Sock & Stocking Aid.
•
CLEANING
Clean your Metal Sock & Stocking Aid using a non-abrasive cleaner or mild
detergent with a soft cloth. Abrasive cleaners e.g. AJAX and/ or abrasive cleaning
pads may damage the product beyond repair and should not be used. Always
ensure that you wipe dry the equipment after cleaning.
REISSUE
If you reissue or are about to reissue this product, please thoroughly check all
components for their safety.
If in any doubt, please do not issue or use, but immediately contact your
supplier for service support.
Usage and Maintenance Instructions
2
Ver. 2 08/2012 (1713)
Werbung
Inhaltsverzeichnis
