iHealth PO3M Bedienungsanleitung Seite 8

10.Do not use the device outside the specified operating temperature range, and do
not store the device outside the specified storage temperature ranges
11.The materials used in the device conform to the biocompatibility and nontoxic
regulations and present no hazard to the body.
12.Use in emergency vehicles with communication systems may affect accuracy of the
measurements.
13.The packaging of the device is recyclable, and it must be collected and disposed
according to the related regulation in the country or region where the package of
the device or its accessories is opened.
14.Any material of the device that may cause pollution must be collected and disposed
according to local rules and requirements.
15.Any single functional tester cannot be used to assess the accuracy of a pulse
oximeter.
16.Do not stare at the lighting LED, as it may irritate your eyes.
17.The device is calibrated to display FUNCTIONAL OXYGEN SATURATION
18.Do not use the device for more than 30 minutes.
19.The wavelength range of pulse oximeter can be especially useful to clinicians
20.Because the pulse oximeter measurements are statistically distributed, only about
two-thirds of pulse oximeter measurements can be expected to fall within ±Arms of
the value measured by a oximeter.
21.The SpO2 accuracy was tested by comparing it to a Co-oximeter and the pulse rate
accuracy was tested by comparing it to a function tester.
22.The device shall not be installed close to or stacked with other devices. When it is
necessary to be close to or stacked with other devices, please observe if the device
can operate normally under such setting first. For recommended measures of
avoiding or reducing such interference, please refer to the section of "ELECTROMAG-
NETIC COMPATIBILITY INFORMATION".
6