Repair Service; Installation - hajdu IDE75F Bedienungsanleitung

HAJDU Hajdúsági Iparművek Rt. as manufacturer hereby certifies that the water heater complies
with quality features described in the quality certificate.

REPAIR SERVICE!

In order to ensure continuous control or in case of failure of the water heater, please, turn to any service
shops contracted with out Company, as described by the „COMMERCIAL WARRANTY". If you are not
satisfied by the repair work performed by these service shops, please turn to the Customer Service of
HAJDU Hajdúsági Ipari Zrt.
Address: 4243 TÉGLÁS
Phone: (52) 582-700 Fax: (52) 384-126
1 installation and owner's manual
1 commercial warranty
Please, check these items at acceptance of the water heater.
DEAR BUYER!
This water heater equipped tank and indirect heating can be operated from either electric energy,
solar energy, or gas-based, coal-based or other based energy carriers.

INSTALLATION

The water heater has to be installed in a location protected from frost, next to the water supply
place. The installation location must be selected in a way that inlet and outlet pipes should be
connected easily with the least possible elbows, furthermore, the close cover and the active anode
should be demounted easily.
FIXING THE WALL MOUNTING WATER HEATER (for types IDE...F and IND...F)
The partition wall selected as the wall for the water heater to be mounted must bear the weight of
the water heater filled up with water, thus, in case of a thin wall, strengthening flat iron items should
be used (on the other side of the wall).
NOTE:
1.) In order to ensure exchange of the active anode, free room of 200 mm should be leaved
under the bottom cover.
2.) The vertical wall mountable water heater of 75 - 200 litre capacity can be placed on a 3
legged scaffold, which is delivered to the Client upon special request.
In order to ensure perfect stability to the water heater, it should be placed on the 3 legged scaffold
and mounted to the wall with the suspension leg, before being filled up with water.
FIXING THE STANDING WATER HEATER (for types IDE...S and IND...S)
Horizontal flat flooring, to guarantee absolutely vertical standing of the appliance. Vertical standing
should be performed with adequate setting or the legs or adequately secure support of the legs.
NOTE:
1.) The unit should be installed in a way that its distance from the wall is at least 50 mm.
2.) In order to ensure easy removal of the close cover and cleaning of the internal side of the
tank, a distance of at least 70 cm should be guaranteed between the fitting house (the front
surface of the water heater) and the wall or other structural building element.
3.) Adequate electric system, pipeline and waste water collection systems (floor drains)
should be ensured on the location of the installation.
The product includes the following accessories within the packaging box:
EN
ATTENTION!
12/48