Safety Instructions; Frequently Asked Questions - i-tec PCE2S1P Gebrauchsanweisung

Quick Start / PCIe to 2S Adapter 2x Serial 1x Parallel(PCE2S1P)
1. Turn off the computer and disconnect it from the power supply of 230V.
2. Unplug the power cord and remove your computer's cover. Remove the slot
bracket from an available PCIe slot and remove the bracket from serial port, too.
3. To install the card, carefully align the card's bus connector with the selected
PCIe slot on the motherboard. Push the board down firmly. Replace the slot
bracket's holding screw to secure the card and screw the serial port card also.
4. Replace the computer cover and reconnect the power cord.
To Verify Windows
Go to the Device Manager (for example, in Win10: the right mouse button on Start-
Device Manager).
You can see new devices under (COM & LPT).
2x PCIe to High Speed Serial Port (COMx)
1x PCIe ECP Parallel Port (LPTx)
NOTE
1. Set communication properties on „PCIe to High Speed Serial Port (COMx)"
as follows (by the right mouse button -Properties):
• on list Properties -Port Settings set proper Bit per second and other
parameters; you can change number of COM port also
• next click on list Properties -Advanced – choose type of port RS232 . Click
on „DMA settings" button and choose required settings of DMA access -
OK; next click on „Adv Baudrates.." button and choose either „Use default
baud rate" or „Use custom baud rate" for settings by your requirements. All
settings confirm OK or with help Defaults you return to default settings.
2. On PCIe ECP parallel port (LPTx)" you can change number of LPT port as
follow (right button of mouse-Properties)::
• on list Properties-Port Settings choose required changes for this portw
Installation for other OS: Drivers are available here: www.i-tec.cz/en/.
Follow the advices in several driver folders (DOS, Linux) for PCIe (PCE2S1P).

SAFETY INSTRUCTIONS

• Do not expose to extreme temperatures and air humidity.
• Use the device on flat surfaces – you will prevent it from slipping and falling
to the ground.
• Save the user manual for a possible use later.
In cooperation with the service department:
• Check functionality after falling to water or to the ground.
• Check functionality when the cover is broken.
• Send the device back if it does not work in accordance with the user manual.

FREQUENTLY ASKED QUESTIONS

Available on our website www.i-tec.cz/en on the "FAQ" tab of this product.
Driver Installation
®
EN
7