Blodgett 901 Einbau Und Betriebsanweisungen Seite 7

OVEN STACKING (if applicable)
900 Series Ovens
1. Place two boards on top of the lower oven.
2. Slide the upper oven on top of the boards.
3. Slide a board under the top oven. Lift up to re- move
the left board.
4. Slide the top section into position Remove the right
board.
Figure 4
1000 Series Ovens
1. Fasten 30,5 cm legs to lower section.
2. Remove the sheet metal flue cover on the bottom of
the UPPER OVEN ONLY. Save the two screws.
3. Fasten the spacers to the bottom of the upper oven.
See Figure 5.
4. Insert oven flue connector into the bottom of the oven
flue. Push until it is flush with the bottom of the upper
oven. Temporarily hold in place with tape.
5. Place the upper oven on top of the bottom oven.
6. Remove the tape. Slide the flue connector into posi-
tion over the collar of the bottom oven.
7. Fasten flue connector to bottom oven with the screws
from the flue cover.
Spacer
Flue Cover
Flue
Connector
5
Installation
Oven Assembly
Spacers
Figure 5