Commissioning - REMEHA iBase Bedienungsanleitung

status LED indication
Off
Flashes once every 4 seconds
Flashes once every second

4. Commissioning

The base station and the controller are usually automatically connected to
each other. The manufacturer ensures this is the case. However, if you replace
either of these components the connection must be re-established. This is
done as follows:
1. Open the housing of the base station.
2. Press the connection button on the base station and hold for three
seconds. The status LED now flashes once per second.
3. Activate the Connection option on the controller (see the controller user
guide). The status LED on the base station now flashes once every 4
seconds.
4. Check the controller to see if a connection has been established; repeat
the procedure if not.
Status
Base station has no power.
Base station is working normally.
Base station is trying to connect with the
controller.
EN
23