Celestron 47011 Handbuch

Personal Weather Station with Wireless
Set Up the Power for the Receiver
Finally, insert the plug into an AC wall type socket and the display will be seen on the Receiver.
For optimum performance, please place the Receiver away from metal and other sources of
interference such as mobile phones, TVs, computers, appliances, etc.
Set Up the Power & Make Settings for the Wireless Remote Sensor
Remove the four small screws from the rear door of the sensor with a small Phillips
head screwdriver. Insert two AAA batteries (user supplied) according to the polarity as
indicated on the sensor (see center image). Set the switch (on the right side) to 1 (for
Channel 1), push/toggle the center switch so readings will be shown in "C"
(Centigrade) or "F" (Fahrenheit). Then push the left switch "TX" which will transmit
the RF signal from the sensor to the Receiver. The Sensor itself will display the outside
temperature and humidity (see left image).
The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to
communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely to any
surface that is secure.
If the battery power becomes low on the Sensor, a "low battery icon" will appear on the LCD display
and change batteries to ensure a strong signal is being sent to the Receiver.
The Receiver has two LR44 batteries installed so that the time and other settings will remain in
memory when the Receiver loses power for some reason. Pull out the plastic insulation sheet from the
back to make it functional.
Remote Sensor
Model # 47011
Plug the socket of the AC Adapter into the
back of the Receiver unit (shown in bottom
right image below). Then install the plug
required for your location (four plugs are
supplied-USA/Europe/UK/Australia).
To change plugs push down on the
indented section (with a small screwdriver
or other small object) and pull the plug away from the adapter --- then
install the plug you want to use into the adapter until you hear it click.