Appliance Features - CombiSteel 7455.1900 Gebrauchsanweisung

Note:
The door should protrude at least 1" beyond the surrounding cabinets.
Electrical Connection
This appliance should be properly grounded for your safety. The power cord of this appliance is equipped with a
threeprong plug which mates with standard three prong wall outlets to minimize the possibility of electrical
shock.
Do not, under any circumstances, cut or remove the third ground prong from the power cord supplied.
This appliance requires a standard 115 Volt A.C. /60Hz electrical outlet with three-prong ground（Product to
America）or 220-240 Volt A.C. /50Hz electrical outlet with three-prong ground（Product to Europe）
This appliance is not designed to be used with an inverter.
The cord should be secured behind the appliance and not left exposed or dangling to prevent accidental injury.
Never unplug the appliance by pulling the power cord. Always grip the plug firmly and pull straight out from the
receptacle.
Do not use an extension cord with this appliance. If the power cord is too short, have a qualified electrician or
service technician install an outlet near the appliance. Use of an extension cord can negatively affect the
performance of the unit.

APPLIANCE FEATURES

Two Temperature Zones

There are two zones in this appliance (Up zone and down zone)

Each zone has its independent temperature control and
display.

Each of the two zones can be used to store wine bottles or
beverages.

the Up zone can hold up to 16 wine bottles and the Down zone
can hold up to 28 wine bottles
Interior Light

Each zone has its own interior light, which can be switched on
or off by pressing the pad (light) on the control panel. Long-life
and high efficiency LEDs are installed for durability and energy
saving.
Engaged Wine Shelves

All the shelves have tabs to engage the cabinet on both sides.

Any of the shelves can be removed to accommodate larger bottles.
To Remove a Shelf:

Remove all bottles (cans) from the shelves.

Lift the shelf upwards and then gently pull out the shelf.
To Replace a Shelf:

Place the sides of the shelves back onto the supporting guides of the cabinet and push back until the shelf
tabs slide into place.
NOTE: Ensure that the tabs are firmly engaged in place before storing any bottles.
www.combisteel.com
5