Milomex Z29748 Montageanleitung Seite 4

½
Ensure that the tent is not too taut when it is
erected, otherwise it may not be able to adapt
to changing weather conditions and might be
damaged.
½
Zips are wearing parts and do not fall under
the guarantee conditions.
½
The polyester material of the tent consists of
water-repellent material.
½
It is possible that during the first rainfall the tent
will not be completely watertight. However, the
threads of the tent will contract when exposed
to water so that after a short time the tent will
become watertight.
½
When exposed to moisture and rain, tent
fabrics expand to varying degrees and make it
necessary to adapt the length of the guy lines.
If the material becomes taut again while drying,
the guy lines have to be loosened again in
good time.
½
Do not use any insect spray in or on the tent.
½
Small leaks on the seams can be repaired with
a seam spray and impregnation spray can be
used for the tent skin.
© Assembly
©
Selecting a pitch
The ground should be flat, clean and as smooth as
possible. Before you erect your tent, remove any
pointed and sharp objects (e.g. stones, branches etc.).
Please ensure that the tent
way that its entrance is protected against the wind.
When selecting a pitch for your tent
remember that you need not only an area for
the floor of the tent, but also room for the guy
lines. You should also ensure that there is
enough space to walk around the tent
that there are no tripping hazards.
© Erecting the tent
Erect the product in accordance with illustrations
A to C.
4 GB/IE
is positioned in such a
1
,
1
and
1
©
Packing the tent together
Please ensure that the tent
dry before you pack it together. Otherwise this
may result in stains and damage to the fabric.
Always fold up the tent
sheet is facing outwards.
The tent pegs and other individual parts must
6
be packed separately in the bags provided.
Otherwise the tent pegs
tent .
1
© Cleaning
For cleaning the tent and removing any stains
you should only use a cleaning agent that is
specifically intended for cleaning polyester tents.
Remove any dirt from the tent
sponge and clean water.
Please allow all parts to dry thoroughly before
you repack the tent
1
mation of mould, bad odours and discolouration.
© Disposal
The packaging is made entirely of
recyclable materials, which you may
dispose at local recycling facilities.
Contact your local refuse disposal authority for more
details of how to dispose of your worn-out product.
is completely
1
so that its ground
1
might damage the
6
with a soft
1
. This will prevent the for-