Inhaltsverzeichnis
Werbung
Motherboard Installation
Installing the Motherboard:
1. Review the documentation that came with your motherboard. Become familiar
with component placement, requirements, precautions, and cable connec-
tions.
2. Power down the system, remove the power cord from the rear of the power
supply and open the chassis cover as described in section 4-2.
3. Compare the holes in motherboard to those in the chassis, then add or re-
move standoffs as needed. To do this:
A. Place a hexagonal standoff screw through the bottom the chassis.
B. Secure the screw with the rounded side up.
4. Lay the motherboard on the chassis aligning the permanent and optional
standoffs
5. Secure the motherboard to the chassis using the rounded, Phillips head
screws. Do not exceed eight pounds of torque when securing the mother-
board.
6. Secure the CPU(s), heatsinks, and other components to the motherboard as
described in the motherboard documentation.
7. Connect the cables between the motherboard, backplane, chassis, front pan-
el, and power supply, as needed. Also, the fans may be temporarily removed
to allow access to the backplane ports.
Figure 4-11: Installing the Motherboard
Chapter 4: Chassis Setup and Maintenance
4-11
Werbung
Inhaltsverzeichnis
