Charging The Battery; Cleaning And Maintenance - Max 43804 Gebrauchsanweisung

Secure small items in a vice or similar. Never
hold the item in your hand!
Check for concealed power cables, pipes, etc.
in the items you are going to screw into. Do
not touch the plastic parts of the screwdriver
during use on masonry.
Make sure that the screw does not damage
any objects under or behind the item, e.g.
when screwing into walls.
Make sure the screwdriver has stopped
completely before changing direction.
Do not press the on/off button if the battery
is fully discharged, as this may damage it.

Charging the battery

Charge the battery fully before using the
screwdriver for the � rst time.
Plug the adapter provided into the mains
socket and insert the charging connector
into the charging socket (2) on the
screwdriver. The charging indicator (3)
remains on.
A full charge takes 3-5 hours.
Unplug the adapter from the mains socket
after charging.
Never charge for more than 5 hours at a time.
Use
Insert the required bit directly into the
screwdriver's bit holder (1) or use the
magnetic holder as an extender between the
bit holder and bit.
Switch the screwdriver on and off using the
on/off button (4).
If you press the top part of the on/off button,
the screwdriver runs clockwise for screwing
screws.
If you press the bottom part of the on/off
button, the screwdriver runs anticlockwise
for unscrewing screws.
When the screwdriver is running, the work
light automatically comes on.

Cleaning and maintenance

Wipe down using a well-wrung cloth after
use, and always keep the surface and
ventilation holes free of dirt.
Never use corrosive or abrasive detergents,
as these may aff ect the plastic parts of the
screwdriver.
If the screwdriver will not be used for a
prolonged period, fully charge it before
putting it away. Charge it at least once every
3 months to maintain the battery capacity.
GB
17