Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
user's instructions
operAtioN - Assembling the foot
1. S lide the two halves of the foot into each other. Make sure that the fan's power cord runs through the
opening, with the plug at the bottom side of the foot.
2. Use the 3 crosshead screws to mount the foot to the bottom of the fan.
3. Place the power cord in the notch under the foot.
operAtioN - Ventilation
S et the time switch to position 'OFF' before connecting the plug to the wall socket; this will make sure
that the appliance does not start immediately.
1. P ut the fan on a level surface, with the grill facing the direction
in which you wish to ventilate.
2. P ush the oscillation button if you wish the fan to oscillate.
Push out if you wish the fan to remain in a fixed direction.
3. Connect the plug to the wall socket.
4. A djust the speed to the required level by pressing one of the
three speed buttons.
Speed 1 the fan operates at low speed.
Speed 2 the fan operates at normal speed.
Speed 3 the fan operates at high speed.
5. S et the timer switch to the required fan operating time. The
fan will automatically stop at the end of the set time. Switch
the timer switch to position 'ON' if you do not wish to use the
timer.
6. Stop the fan by turning the timer switch to position 'OFF'.
cleANiNG ANd MAiNteNANce
From time to time dust can accumulate in the fan housing, and on the fan blades. Remove the dust with a
brush and/or vacuum cleaner.
• Verify that the appliance is not connected to the power supply before you clean it.
•
Make sure no moisture gets into the appliance.
•
N ever use corrosive or scouring cleaning agents or sharp objects (such as knives or hard brushes)
to clean the appliance.
the eNViroNMeNt
•
D ispose of packaging material, such as plastic and boxes, in the appropriate waste containers.
•
W hen this product reaches the end of its useful life do not dispose of it by putting it in a dustbin;
hand it in at a collection point for the reuse of electrical and electronic equipment. Please refer to
the symbols on the product, the user's instructions or the packaging.
•
T he materials can be re-used as indicated. Your help in the re-use, recycling or other means of
making use of old electrical equipment will make an important contribution to the protection of the
environment.
•
C ontact your municipality for the address of the appropriate collection point in your neighbourhood.
0
100
Figure 3. Control panel
17
Figure 2
Assembling the foot
STOP
OSCILLATION
1
2
3
ON
120
OFF
20
80
40
60
Werbung
Inhaltsverzeichnis
