Installation; Operation; Maintenance; Packing List - CombiSteel Hurricane Gebrauchsanweisung

4. INSTALLATION

1. Installation must be carried out in accordance with the current edition of the local wiring regulations code
having jurisdiction. Installation should be performed only by a qualified electrician.
2. Place template against wall at desired height (see mounting height recommendations) and mark locations of
4 mounting holes Dia. 8mm (5/16").
3. Remove and retain 2 side security hex cover screws and cover. Then mount the hand dryer base on the wall.
4. Before replacing the cover, there is an option to run the dryer heater on or heater off. The switch is clearly
marked.
5. Replace cover. Do not over-tighten screws.
6. Connect the hand dryer plug to the power supply.
a. Connect the live wire (coloured Brown or Red) to the terminal block marked "L".
b. Connect the neutral wire (coloured Black or Blue) to the terminal block marked "N".
c. Connect the ground wire (coloured Green or Yellow) to the terminal block marked "E".

5. OPERATION

• No-touch operation.
• There is a blue LED light to guide user to the air flow.
• Shake excess water from hands.
• Place hands under the outlet to start operation.
• Rub hands lightly and rapidly.
• Stops automatically after hands are removed.

6. MAINTENANCE

• Periodic cleaning of the unit is recommended.
• Remove cover and clean dryer dust lint.
• Wipe the cover with a damp cloth and mild cleaning solution. Do not soak.
• Never use abrasives to clean the cover.

7. PACKING LIST

Hand Dryer: 1PC
User Manual: 1PC
Installation Template: 1PC
Plug in Dia. 8x38mm: 4PCS
Screw in Dia. 5x36mm: 4PCS
Hex screwdriver: 1PC
www.combisteel.com
5