LAZER Mambo Evo Bedienungsanleitung Seite 7

ADJUSTING AND USING
THE MICROMETRIC BUCKLE (fig. 1)
1. First, adjust the length of the strap by rolling it
through the plastic adjustable strap (A)
2. To close the buckle, insert the ratcheted tongue
(B) into the casing (C). When you hear a "click",
the buckle is closed. The multi-notching allows
for minute adjustments in order to obtain perfect
comfort and fit with the buckle
3. If necessary, go back and repeat Step 1
4. To open the buckle, pull on the red strap (D) and
draw back the ratcheted tongue using your other
hand
WILL IT STAY ON? (fig. 2)
You want to know the helmet you buy will stay firmly on
your head in a crash. Make sure the chinstrap is done
up and tilt your head forward. Ask someone to try and
roll the helmet off your head by carefully pushing up
from the rear of the helmet at its base. If you can roll
it off in the showroom, then it's sure to come off in a
crash.
HOW TO CHANGE THE INTERNAL SUN VISOR
ON YOUR HELMET (FIG.3)
• The internal sun visor must be in the lowered
position (E)
• Hold the internal sun visor between 2 fingers
on each end of the visor (F) and pull it gently
forward until the 2 clips situated on the internal
sun visor detach from the 2 lugs situated inside
the mechanism (G)
To replace the visor:
• Slide the visor back as far as it will go, until you
hear a double click (on each side), indicating it is
clipped correctly on the lugs (H)
• Ensure the mechanism is working properly (I-J)
HOW TO REMOVE AND REPLACE
CHEEK PADS BACK ON YOUR HELMET (fig. 4)
• Cheek pads are fixed to the helmet by means of
3 snaps on their sides and a collar of plastic slid
between the shell and the base (K)
• Detach the pad from the 3 snaps and pull to tear it
from the shell (L)
To put the pad back on:
• Insert the collar between shell and EPS base (M)
• Snap the 3 press studs on the side of the EPS base
(N)
HOW TO REMOVE AND REPLACE
THE HEAD PAD ON YOUR HELMET (fig. 5)
• Pull the head pad on the neck to unsnap the 2 press
studs (O)
• Pull the head pad on the front to unsnap the 2 press
studs (P)
• Remove the entire head pad from the helmet (Q)
To put the head pad back on:
• Introduce the whole head pad inside the helmet (R)
• Snap the 2 press studs of the head pad on the neck
• Snap the 2 press studs of the head pad on the front
PEAK INCLUDED IN THE BOX (fig. 6)
How to put the peak?
See fig. 5
W W W . L A Z E R H E L M E T S . C O M
- 7 -