Tips For Best Results - Beper 40.960 Betriebsanleitung

6 in1 Hair Clipper Set Use instructions
TRIMMING THE NAPE OF YOUR NECK (Diagram 3 & Diagram 4)
Note: You will need a hand mirror for this operation if performing it alone .
Before you begin, attach the full size trimmer attachment .Then attached to the precision trimmer
attachment
Use your fingers to lift the hair at the base of your head up off the neck. Your index finger should be
covering the roots of the hairs you are lifting to prevent accidental removal by the personal groomer.
Using your other hand, hold the personal groomer to the base of your neck with the cutting unit
facing up, and move the personal groomer up the length of the neck until it touches your finger co-
vering the hair roots at the base of your head.
Be sure to move the unit slowly when performing this operation and to keep the hair roots at the
base of your head out of the way of the trimmer.
TO REMOVE HAIR FROM NOSE AND EAR (4) (Diagram 5 & 6)
Attach the nose trimmer attachment
Insert the personal groomer gently into nostril or ear
Gently move the groomer in and out of the nostril or ear and at the same time rotate
Avoid inserting the cutting unit more than 6mm into your nostril or ear .
TO REMOVE HAIR FROM EYEBROWS (Diagram 7)
Attach the nose trimmer attachment
Gently guide cutting unit to stray, unwanted hairs along the eyebrow line or protruding from the
eyebrow itself.
To remove the hairs completely lower onto the skin and move over desired area
Use slow and well-controlled movements.

TIPS FOR BEST RESULTS

Remove trimmer comb attachment (6) if you are: defining hairline edges such as sideburns. Trim-
ming the nape of your neck , trimming your beard line on front of neck .
CARE FOR YOUR PERSONAL GROOMER
CLEANING AND MAINTAINING YOUR PERSONAL GROMMER
AFTER EACH USE
Turn the personal groomer off
Gently brush the remaining hairs away / rinse under warm water from the guide comb and trimmer
blade
CLEANING CAUSIONS
the guide comb attachment and trimmer blade may be removed from the product for cleaning
Cleaning should only be done with a soft brush, such as the brush supplied with the product .
Use the light-grade oil supplied or sewing machine oil on the blades.
Do not use harsh or corrosive cleaners on the units or their blades.
12