Yamaha SPS-LF101 Aufstellungsanleitung Seite 3

ASSEMBLED SPEAKER STAND
NS-F101
SETUP PROCEDURES
You will need a Philips screwdriver for assembly of
the speaker stand.
Be sure to use the correct screw type as described.
1
Affix the non-skid pads as shown below.
Base
SETTING UP THE SPEAKER STAND
Non-skid pads
(for base)
2
Attach the support to the bottom of the base
with the exclusive base mounting screws.
* Do not overtighten the screws. Doing so may
damage the screws or assembly.
* Adjusting the position of the mounting screws
even minutely may damage or scratch the
support and the bottom of the base. Please
take care not to damage them during
adjustment.
Exclusive base
mounting screws
Non-skid pads
(for base)
3
Pass the speaker cable through the support
from the under side of the base. Pass the
speaker cable through the larger hole of the
support.
Base
Support
Speaker cable
(included with NS-F101)
Base
3
E-