Herunterladen Diese Seite drucken

Federal Communication Commission Interference Statement - Nokia Sleep Installationsanleitung

Werbung

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of
the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by
the party responsible for compliance could void the user's authority to
operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Important note: Radiation Exposure Statement
The product comply with the US portable RF exposure limit
set forth for an uncontrolled environment and are safe for
intended operation as described in this manual. The further
RF exposure reduction can be achieved if the product can be
kept as far as possible from the user body or set the device
to lower output power if such function is available.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
10

Werbung

loading