Movon R7 Bedienungsanleitung Seite 4

Active Call Mode Blue LED blinks 3 times every 5 seconds
Streaming Mode Blue LED blinks 2 times every 5 seconds
Charging in Progress Red LED turns on
Charging Complete Red LED turns off
2. Tone Indication
Status Tone Indication
Power On Turn-on melody
Power Off Long Beep
Connect 3 Short Beep
Incoming Call Ring melody
Active Call 2 Rising Beep
Ending a Call 2 Falling Beep
Low Battery Low Battery beep
SPECIFICATIONS
Model Name R7
Bluetooth Core Spec Bluetooth Specification 2.1+EDR
Profile HSP, HFP1.5, A2DP, AVRCP
Carrier Frequency 2400 MHz to 2483.5 MHz
Modulation Method GFSK, 1Mbps, 0.5BT Gaussian
Maximum Data Rate Asynchronous : 2178.1 kbps / 177.1 kbps
Synchronous : 1306.9 kbps / 1306.9 kbps
Bluetooth Class Class 2
Hopping 1600 hops/sec, 1MHz Channel Space
Transmit Power 0 dBm
-5-
Coverage Range
Receiver Sensitivity
Continuous Talk Time
Music Time
Standby Time
Weight
Dimension
Charging Voltage
Charging Time
Operating Temperature
Storage Temperature
Battery
SAFETY AND GENERAL INFORMATION
1. Please read this guidebook carefully and follow the instruction.
2. To avoid any damage or malfunction of the unit, do not drop it from high place.
3. Keep away unit from humidity, water and any other liquid. And if the unit is exposed by water, moisture and other liquid directly,
then do not operate it normally to avoid any electrical shock, explosion and damage of the unit.
4. Do not place or keep the unit near the heat sources such as direct sun light, radiators, stoves or other apparatus which produce heat.
It may cause explosion, degrade of performance and reduce battery life.
5. Do not modify, repair & disassemble unit at discretion. [especially battery: it may cause an explosion]
6. Do not place the heavy objects on the unit.
7. Use only supplied and approved charger.
8. Replacement or service must be done at a qualified service center or manufacturer.
9. Unplug this unit when unused for long period of time or during lightening storms.
[CAUTIONS] ELECTRIC SHOCK HAZARD : The battery used in this device may present a risk of fire or chemical burn if mis-treated.
FCC STATEMENT
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received , including interference that may cause undesired operation.
[Note] The manufacturer is not responsible for AzNY interference, for example RADIO or TV interference, caused by unauthorized
modifications to this equipment. Such modifications could void the user's authority to operate the equipment.
English
10 Meters
-82 dBm / 0.1 % BER
4 Hours
4 Hours
170 Hours
10 g
18.1(H) x 51.3(L) x 9.5(H) mm
DC 5.0 ~ 5.3 V
2 Hours
-10° to +50°C
-20° to +80°C
Lithium Polymer 3.7V 90mAH
-6- English