aidapt Coniston VR130 Aufbau- Und Wartungsanleitung Seite 5

TESTING THE UNIT
Before using the seat it is important that you test it has been installed correctly.
Test the unit by rotating the unit a full 360
predetermined lock points which are set at 90
To rotate the seat lift the locking levers on either side of the seat (see fig. 6) and rotate the
seat to the desired lock point.
Finally retest for rotation and stability. If you are satisfied then your Coniston rotating bather
is ready for use.
It is important that you test the Coniston rotating bather for security prior to
each use. If the seat or frame is loose in any way, please repeat the installation
instructions above.
FITTING THE EXTENSION PIECE
If required the Coniston bather extender can be fitted to provide extra height to the seat (see
fig. 7). To fit, carefully separate the seat section from the base section and bolt the extender
on the base section using the four locking nuts and bolts provided.
After ensuring that all four bolts are tightly secured, place the seat section
back into place ensuring that the spline of the extension piece fully locates
into the female locator hole on the base of the seat
Test the extension piece by rotating the seat through 360
seat into each of the predetermined lock points set at 90
It is important that you test the Coniston rotating bather for security prior to
each use. If the seat or frame or extension piece is loose in any way, please
repeat the installation instructions above.
The use of the Coniston bather extender will alter the centre of gravity. It is
strongly advised that you use the wall stabilizing plate in conjunction with the
extender to reduce the chance of tilt.
CLEANING
All of the product components are manufactured from quality materials. However, it is very
important that you only clean your Coniston using a non-abrasive cleaner or mild detergent
with a soft cloth avoid using lime scale remover. Abrasive cleaners e.g. AJAX and or abrasive
cleaning pads will seriously damage your product beyond repair.
N.B. Regular daily cleaning will reduce the build up of lime scale on your product.
UNDER NO CIRCUMSTANCES must you use any abrasive cleaners or materials on any of the
components.
Fixing and Maintenance Instructions
o
fig. 5
and checking that the Coniston locks into the
o
intervals (see fig. 5).
fig. 6
o
and locking the
o
intervals.
5
fig. 7
Ver.4 08/2012 (1562)