Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
Congratulations for your excellent choice.
In addition to its quality and reliability, our CENETOP ash cleaner is built for easy and safe long-term use.
This appliance has been designed for the suction of cold ash only, and for such reason is not suitable for boilers or for
fuel oil stoves nor can it be used for plaster powder or cement dust. This appliance is designed for domestic use
only.
IMPORTANT - Safety warnings - Read carefully before use
-
Do not leave the ash vacuum cleaner plugged in when not in use. Always stop the appliance with the
ON/OFF switch before taking the plug out of the socket.
-
Do not pull the lead. To unplug, grasp the plug, not the cable.
The use of an extension cable is not recommended.
-
Do not pull or carry by cable or use cable as a handle.
-
Do not use to vacuum water or other liquids.
-
Do not use to pick up flammable or combustible liquids, such as petrol, or use in areas where they or their
vapours may be present.
-
The cover of the motor compartment must only be cleaned with a dry cloth.
-
Do not leave the ash vacuum cleaner outdoors, it must always be kept in a dry place and not where it could
be affected by bad weather conditions.
-
Do not handle any part of the plug or appliance with wet hands.
Do not disassemble the appliance as incorrect reassembly may result in an electric shock or fire.
-
Do not stretch the cable or place the cable under strain. Keep the cable away from heated surfaces. Do not
-
close a door on the cable, or pull the cable around sharp edges or corners. Arrange the cable away from
traffic area and where it will not be stepped on or tripped over.
-
Do not pick up anything that is burning or smoking, such as cigarettes, matches, or hot ashes.
Keep hair, loose clothing, fingers, and all parts of body away from openings and moving parts, such as the
-
brush bar. Do not point the hose, wand or tools at your eyes or ears or put them in your mouth.
Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and
-
anything that may reduce airflow.
-
To avoid a tripping hazard wind the cable when not in use.
-
Hold the plug when rewinding onto cable reel. Do not allow the plug to whip when rewinding.
-
Electric lead : if the electric lead is damaged, it must be replaced by the manufacturer, by the manufacturer's
customer service or by qualified people.
-
This device is not intended for use by people (including children) with limited physical, sensorial or mental
capacities or by people lacking in experience or knowledge unless they are assisted or shown how to use
the appliance by a person responsible for their safety.
HOW TO PREPARE AND USE THE ELECTRIC ASH VACUUM CLEANER
-
Position the appliance on a flat surface.
-
Remove the accessories from the drum and insert the 4 wheels in the plastic base.
Make sure that the HEPA filter and the pre-filter have been inserted in their housings (as indicated in Fig. 1)
-
Connect the steel pipe to its fitting. (fig. 2)
-
Before starting to clean the stove, make sure that all the ash has stopped burning and is sufficiently cool.
-
Never suck burning embers.
-
Plug the electric lead into a socket, making sure the voltage is suitable for the characteristics of the
appliance, check the rating label on the appliance.
-
Turn the appliance on using the luminous ON/OFF switch located on the cover of the motor.
-
Vacuum the ash directly from the fireplace or from the stove using the steel pipe.
-
Whenever suction power appears to be decreasing, the Cenetop ash cleaner is designed to permit the
cleaning of its filter during use:
Werbung
Inhaltsverzeichnis
