Maestro MR800 Bedienungsanleitung Seite 7

Notes: Please use fresh fruits and vegetables to make the juice.
The stale fruits and vegetables that have been stored in refrigerator
for a long time shall be used after being immersed in cold water for
over 10min. The kernel of fruits must be removed.
- Install the juicer conductor in accordance with the
assembly diagram. Do not forget to lock the cover with the "F" locks
by hooking them with the upper parts by the cover and lowering
them downwards. If the device is not correctly assembled, the locks
will not snap into place and the juicer will not start running.
- The device should be installed on a smooth, dry, heat-
resistant nonskid surface, as close as possible to the outlet.
- Prepare vegetables and fruits for pressing.
- Insert the plug of the juicer into the socket. The switch
"H" must be set to the "0" position.
- Turn on the juicer by turning the "H" switch to "I" to turn
on the first speed or to the "II" position, to turn on the second speed.
- Add prepared pieces one at a time to the delivery orifice
each time by gently pressing at placed pieces with the special
pusher "A". If you press to hard, you can significantly reduce the
juice extraction or even break the juicer.
- You can also use the impulse mode to turn on the device.
To do this, prepare a small portion of the product, than turn and
hold the switch "P" for 15 seconds. During this time, use a small
prepared portion and release the switch, the juicer will turn off.
For next minute while the juicer is cooling down, you can prepare
the next portion of the product, as well as empty the containers
from the juice and pulp. In this mode, you can conduct up to thirty
consecutive cycles and get up to three liters of juice.
- Do not start work, for about 50 minutes, if the juicer has
not cooled down after the last cycle of work.
- At the end of work, set the speed switch "H" to "0",
disconnect the juicer from the mains and drain the juice from the
juicer container
Instructions for use
7
EN