Care And Maintenance Nce Ce; Maintaining And Cleaning The Faucet; Replacing The Cartridge - Miomare 78510/II Montageanleitung Und Bedienungsanleitung

completely, but simply loosen it until the handle
can be easily removed.
1
3. Remove the handle
4. Unscrew the cartridge end ring
the red adjusting ring
help of a screwdriver.
Note: Press the cartridge pins slightly back-
wards. This makes it easier to pull up the ad-
justing ring . Do not use pliers. Do not re-
6
lease the cartridge
the cartridge.
5. Reducing the hot water flow rate:
Replace the setting ring
G/1 in offset position.
Restricting the hot water flow rate
completely: Install the setting ring
shown in Figure G/2.
Deactivating the hot water flow rate
limitation: Install the setting ring
shown in Figure G/3, neutral position.
6. After setting the scald protection device, re-
place the cartridge cover ring
dle .
1
©
Care and maintenance
©
Maintaining and cleaning the
faucet
Please note that sanitary fittings require special care.
Please observe the following instructions: owing inst owing instru
Dry your fittings with a cloth after each use to gs with wi
prevent any build-up of lime deposits. y build-up o build-up o
Clean your fittings with clean water, mild deter- our fittings wi our fittings
gent and a soft cloth or leather only. and a soft clo nd a soft c
Do not use any agents to remove limescale, o no not use any t use
acidic clean acidic cleaning agents or scouring agents of cidic cle
any ki any kind any kind. Do not use corrosive or alcohol-con-
taining agents for cleaning (including for col- tain tainin
ou oured surfaces).
Screw out the aerator
and remove lime deposits and any foreign bodies.
Replace the aerator with a new one if it is very
heavily contaminated or damaged. A new aera-
tor
can be ordered from the service centre in-
10
dicated.
.
1
. Now pull
4
upwards with the
6
nut and do not take off
7
as shown in Figure
6
as
6
as
6
and the han-
4
aning th ning th
ttings req ngs re ire i
a cloth a cloth
at regular intervals
10
How to use / Care and maintenance
Note: In normal circumstances the aerator
can be unscrewed by hand. If this is not the
case, use a 23 mm spanner and wrap the
aerator in a thin, damp cloth, so that it is not
damaged. You can also use a pipe wrench
with plastic jaws. Take care not to damage the
aerator .
10
If the care and maintenance instructions are not fol-
lowed, damage to the surface of the fitting can be
expected. Claims under the warranty are excluded
in this case.
©

Replacing the cartridge

he cartri he cartr
A cartridge is a wear p is a wear part that needs replacing a wear
7
according to the hardness and / or degree of con- o the hardn the hard
tamination of the water. This becomes evident n f the wa f the w
when the handle the hand he han becomes difficult to move.
1
New cartridges ew cartridges cartrid can be obtained from the
7
listed service office. listed service ed serv
Proceed as follows to replace the cartridge Pr Proce oc
1. Shut the main water supply off. Al- 1.
low the remaining water to run off.
2. Remove the hot / cold plate
the locking screw
2
an anticlockwise direction.
3. Pull the handle upwards and off.
1
4. Unscrew the cartridge cover ring
5. Release the cartridge securing ring
it with a size 32 spanner and pull the complete
cartridge out of the body
7
6. Place the new cartridge
the faucet in exactly the same way. Make sure
that the seal is fitted properly under the cartridge
. Make sure that the guides are in the corre-
7
sponding holes.
7. Replace all aforementioned parts. Tighten the
cartridge securing ring
holding the faucet in place against the rotating
movement. This ensures tightness and prevents
the lever motion from becoming sluggish.
10
are not fol- re not fo
fitting can b ng can b
nty are excl nty are excl
:
7
and unscrew
3
with the Allen key in
30
.
4
beneath
5
of the faucet.
9
into the body of
7 9
hand-tight whilst
5
GB/IE 9