Scope Of Application - HAWA Powerlec Vario Originalbetriebsanleitung

6.3 LED for illuminating the working area
A LED illuminates the working area after activating the trigger. It automatically switches off 15 sec. after releasing the trigger.
The lighting can be switched off as follows:
1. Remove the battery
2. Press and hold control switch (item 7)
3. Insert battery
4. Release control switch
Switch on again:
1. Remove the battery
2. Insert battery again (without pressing the control swith (item 7)

6.4 Scope of application

With the electro-hydraulic punching device Powerlec Vario various shapes can be punched with a number of different punch sets. In addition to steel,
stainless steel (V2A and V4A) and aluminum sheets, fiberglass and some plastics can also be processed under favorable conditions. Preliminary test
attempts are advised in these cases.
The following table reflects the limits of the punched hole sizes:
Material Sheet metal thickness
St 37 2,5 mm
Stainless steel (V2A) 2,0 mm
Combinations not reflected in this table, where doubts exist about the punching ability, we recommend that you contact our Service Center for advice.
Caution: Only within the intended use may approved materials be punched.
Should other materials be punched, it is mandatory that you consult with the manufacturer first.
Before starting to punch please make sure that all parts involved in the punching process are not connected to live circuits.
6.5 Instructions for battery and charger
In addition to the Powerlec Vario original instructions, instructions for the quick charger is included in the delivery of this device. It contains important
safety and operating instructions, which is imperative to read before commencing.
Fig. 2
Short description of the charging process
The charger is designed for 230 V AC / DC with a frequency of 50 HZ.
New batteries should be recharged before initial use.
1. Plug the power cord of the charger into the mains. The charge control light will flash green repeatedly.
2. Align the battery on the charger through the slide guide till the stopper. The terminal cover of the charger opens through the insertion of batteries
and closes when the battery is pulled out.
3. When a battery is inserted, the red charging indicator lights up, the charging process begins with a preset short tone (beep).
4. When charging is completed, the charge control light switches from red to green, and a tone (beep) is made to report the completion of the
charging process.
5. The charging time varies depending on the temperature (10 °C - 40 °C) at which the battery is charging and the battery condition (e.g. new or if
the battery has been unused for an extended time).
6. Once loaded, remove the battery from the charger and unplug the charger from the mains.
Type
Round punch up to ø 80 mm
Square punch up to 68 mm x 68 mm
Rectangular punch up to 115 mm diagonal
Round punch up to ø 80 mm
Square punch up to 68 mm x 68 mm
Rectangular punch up to 115 mm diagonal
10 - 40°C
Fig. 3
(BL1815)
15 min.
(BL1830)
22 min.
Li-ion
17