Remote Control; How To Install Batteries; Cleaning And Maintenance - RUSTA 906512310101 Gebrauchsanweisung

ENG

REMOTE CONTROL

HOW TO INSTALL BATTERIES

1. Open the battery box on the back of remote control,
and install One button battery (CR2032V).
2. Put the battery inside the slot, with anode and cathode
in right directions.
3. Put on the back cover.
Slide the cover to open Be sure the direction is correct.
Notice:
1. The anode and cathode of the batteries must be corresponding to the signs of "+" and
"-" on the remote controller.
2. For long time no use, take out the battery.
3. To prevent environmental pollution, take out the used battery and dispose safety and
appropriately.
HOW TO USE
To operate the convector heater, aim the Remote controller at the signal receptor. The
remote controller at a distance of up to 6m when pointing at signal receptor of the fan
heater.

CLEANING AND MAINTENANCE

1. Before undergoing maintenance, please disconnect the power cord plug out the power
source, can be carried out after 10 minutes cooling down.
2. The surface area of dust, with a soft cloth to wipe; When the surface is too dirty,
available below 50 degrees Celsius of the mixture of water and neutral detergent
touch water to wipe with a soft cloth and dry.
3. Dry off the surface with a soft damp cloth. Do not use any corrosive or abrasive
cleaners. Scratches on the surface can cause rust.
4. Product when not in use for a long period of time, unplug the power plug, wrap the
machine to prevent dust into the machine.
5. When the heater should be cold, dry, packaged storage and dry ventilated place as this
may damage the appliance.
6. In case of breakdown and/or poor functioning of the appliance, disconnect the
appliance from the power supply and contact an authorized repairer.
6