Gb User Instructions; Positioning The Antenna - MELICONI AT55 Gebrauchsanleitung

"AT55" AMPLIFIED INDOOR ANTENNA
FOR DIGITAL TERRESTRIAL SIGNALS
USER'S INSTRUCTIONS
The AT55 amplifi ed indoor antenna receives standard and HD digital terrestrial TV signals and
DAB radio signals in the VHF (band III) and UHF bands.
The antenna may be connected to a television set or a digital terrestrial decoder.
WARNINGS
- Keep away from water: the antenna must not be exposed to drips or sprays of water. Do not
use in a damp environment or outdoor.
- The device must not be connected to any other power supply than the one it is supplied with.
- The power supply unit must be easily accessible to enable the electric separation of the device
from the electrical mains supply.
- Disconnect the devices from the electrical mains supply before connecting them together.
- Do not tamper with, or attempt to repair the device – danger of electric shock.
- In the event of a fault with the power supply unit, disconnect it from the electrical mains socket
immediately.
A
For best reception, position the antenna near a window or an external wall, away from metallic
objects, electrical equipment and walls in reinforced concrete, which may affect its performance.
B
- Connect the Meliconi antenna cable to the socket on the rear of the television set or digital
terrestrial decoder (fi gure 1). If the decoder is fi tted with an F-female type antenna socket,
use an F-male plug to IEC-female socket adapter (not included).
- Use the AC/DC power supply included in the kit to power up the antenna: insert the cable in
the antenna power supply input and connect the power supply unit to the mains power supply
(fi gure 2). Alternatively, in the case of certain decoders the power supply can be supplied
directly via the antenna cable (see the TV or the decoder manual).
- Switch the antenna in using the switch (A), which is built-in in the power unit jack. For the best
gain, turn the amplifi cation control device (B) on the rear of the antenna counter-clockwise.
- Check that the antenna has been switched on correctly: the red LED on the front of the
antenna must be illuminated.
- Switch the television set (or the digital terrestrial decoder) on and select the desired channel.
If necessary, perform the TV tuning or the decoder tuning referring to the relevant manual.
Thank you for choosing MELICONI.

Positioning the antenna

Installation
GB
5