Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Important safety instructions
1.
To obtain full use of the cabinet, we recommend reading this instruction manual.
2.
It is the user's responsibility to operate the appliance in accordance with the instructions given.
3.
Contact your dealer immediately in case of any malfunctions.
4.
Place the cabinet in a dry and ventilated place.
5.
Keep the cabinet away from strongly heat-emitting sources and do not expose it to direct sunlight.
6.
Always keep in mind that all electrical devices are sources of potential danger.
7.
Do not store inflammable material such as thinner, gasoline etc. in the cabinet.
8.
We declare that no asbestos nor any CFC are used in the construction.
9.
The oil in the compressor does not contain PCB.
Unpacking and installation
Remove the wooden pallet and the packing.
To ensure correct function it is important that the cabinet is level. If the cabinet is supplied with legs, these can
be adjusted. See fig. 1.1.
If you want to build in your cabinet please note the following:
1.
There must be at least 15 cm free space above the cabinet in order for the cooling system to work
satisfactorily.
2.
There must be sufficient space at the hinge side to clean and replace the shelves and clean around the
hinge.
Electrical connection
The cabinet operates on 230 V/50 Hz. The wall socket should be easily accessible.
All earthing requirements stipulated by the local electricity authorities must be observed. The cabinet plug and
wall socket should then give correct earthing. If in doubt, contact your local supplier or authorized electrician.
The flexible cord fitted to this appliance has three cores for use with a 3-pin 13-Amp or 3-pin 15Amp plug. If a
B.S. 1363 (13-Amp) fused plug is used, it should be fitted with a 13-Amp fuse.
The wires in this mains lead are coloured in accordance with the following code:
Green/Yellow: Earth, Blue: Neutral, Brown: Live.
The main electrical connections must be done by skilled electricians.
Start-up of the cabinet
Before use, we recommend that the cabinet is cleaned, see the section on maintenance and cleaning.
Important !
If the cabinet has been horizontally placed during transport, please wait 2 hours before starting up the cabinet.
In order to assure optimum function of the cabinet the ambient temperature must be between 18 and 35°C.
3
Werbung
Inhaltsverzeichnis
