Maintenance And Cleaning - HAZAN MIRAGE 50 Bedienungsanleitung

ASSEMBLY FOR DRY VACUUMING FUNCTION
EN
• Unlock the locking latches pulling outwards to the right and left.
• Put the motor bonnet away through holding it from carrying handle.
• Insert cloth filter bag into the tank.
• Insert paper dustbag into the tank.
• Make sure that paper dustbag and cloth filter bag are plugged in dry
vacuuming function.
• Put the motor bonnet back on the tank and lock the latches by pushing
right and left.
• Plug the attached tubes to the hose handle. Instead of using two
extension tubes, you can use your machine with only one tube or without
any extension tube by connecting accessories directly to the hose
handle.
• Insert the hose by pushing it into the suction mouth.
• Plug-in your machine's cable to the power socket.
• Operate your machine by using ON-OFF switch.
• By moving forward and back your suitable accessory for the surface you
want to clean, make dry vacuuming function.
NOTE: You can arrange suction power by opening and/or closing the
air discharging hole on the hose handle.
• Switch off your machine and pull the plug from the socket before starting

maintenance and cleaning.

• Do not wash the motor bonnet and do not put it in water. Only clean it by
mopping.
• Clean the tank by mopping or washing.
• Clean the accessories by mopping or washing.
• Clean cloth filter bag by shaking off. Do not wash or put it in water.
• Change paper dustbag with a new one after getting full.
• You may clean the hepa filters by shaking them in a case with water. or
with a wet plastic brush.
IMPORTANT: Do not clean hepa filters under water or with a metal
brush.
NOTE: Always keep a reserve of paper dustbag to use machine when
needed.
MAINTENANCE AND CLEANING