Konig Electronic FTA DVB-T SCART receiver Anleitung Seite 4

3.2. Main Menu
When you press [Menu],you can enter the main menu. The screen below will be displayed.
1. Press [Up/Down] to navigate between Channel,
Installation, etc.
2. Press [OK] to enter the selected menu.
In "Installation" menu:
1. Press [Up/Down] to navigate between the menus.
2. Press [OK] to enter the selected menu.
3.2.2. Auto Scan
When you enter the "Auto Scan" menu, the screen shown below will be displayed. If channel lock is on,
enter your password first. Default password is "0000".
1. Please select the country in System Setup Menu /
Region and Time / Region, for example "France".
2. In "Scan Mode", press [Left/Right] to choose between
scanning all channels or only free channels.
3. Move the highlighted section to "Search" and press [OK]
to start scanning.
4. In the "Auto Scan" menu, press [Exit] to leave the
scanning process.
3.2.3. Channel Scan
When you enter the "Channel Scan" menu, the screen shown below will be displayed.
1. There are two modes for channel scan. You can scan
channel by channel or by frequency.
2. When the scan band is selected on UHF and the chosen
region is "France", the range of Ch No. is from 21 to 69.
When the scan band is selected on VHF and the chosen
region is "France", the range of Ch No. is from 1 to 9. (it's
according to region)
3. When you complete your modification, move the
highlighted section to "Search" and press [OK]. The
scanning process will now begin..
4. Press [Exit] to leave the scanning process.
4