Inhaltsverzeichnis
Werbung
reference. The original instructions were written in the Hungarian language.
This appliance may only be used by persons with impaired physical, sensory or mental capabilities, or lacking in
experience or knowledge, as well as children from the age of 8, if they are under supervision or have been given
instruction concerning use of the appliance by a person responsible for their safety and they have understood the
hazards associated with use. Children should not be allowed to play with the unit. Children may only clean or perform user
maintenance on the appliance under supervision.
• outstandingly high sensitivity • ideal for receiving radio and TV broadcasts • can be used to receive both analog and
digital signals wall mount and metal clamp included • can be hanged, screwed or with the clamp fixed to a rod • power supply:
12V
network adapter, included • inbuilt „F" socket necessary to obtain a connection cable for it
SETUP
1. Before using the antenna an antenna cable must be obtained the in the required length. Depending on the placement usually a 5-15
meter long connection cable is necessary. On one end of the cable an F plug on the other end a coaxial plug must be installed.
2. Plug the "F" plug into the antenna, and the coaxial plug into the black box (amplifier)
3. Connect the wire of the network adapter into the black box, then the adapter to the network, and turn the amplifier on.
4. Connect the antenna plug into the receiver device (television, radio, set top box...). Turn the device on and tune the programs.
5. By changing the position of the antenna, find the optimal receiving place. Only after this is done fix the antenna to its final place.
• The quality of reception is greatly influenced by the placement of the antenna. Do not place it in the immediate vicinity of electronic
devices, or larger metal objects, because those can deteriorate the reception!
• The device can only be separated from the network by unplugging power cable from the mains!
INSTALLATION
Make sure, that the antenna is fixed safely and stable! The design of the stand is appropriate for both horizontal and vertical placement.
The screw fixing the antenna to the stand must be tightened firmly, but with making sure the plastic parts do not crack. The support arm can
ben hanged, screwed, or with the included metal clamp fixed to an antenna rod.
• Occasionally make sure that the fixing screws did not loosen, and that the supporting arm is not damaged!
CLEANING AND MAINTENANCE
Occasionally check the stable contact of connectors! The stains form the casing can be removed by using a slightly humid cloth. Do not
use aggressive chemicals!
WARNINGS
• If you notice any abnormalities, or if the network adapter is damaged, immediately cut the power from the device, and contact a
specialist!
• Never connect the adapter to the network with a wet, moist hand!
• If not in use for a prolonged period cut the power by unplugging the network adapter.
• The adapter and the amplifier are only usable indoor, under dry circumstances!
• Due to continuous development, the technical data and design can change without prior notice.
• We do not take responsibility for the possible printing errors, and are sorry if any occurs.
dvb-t/t2 outdoor antenna with signal amplifier
Before using the product for the first time, please read the instructions for use below and retain them for later
EN
FZ 56
Werbung
Inhaltsverzeichnis
