Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
24-ZONE (24-hour zone mode):
with "24-ZONE" terminal, means it will work as a 24-hour zone
sensor, siren will alarm immediately once it is triggered.
Installation Mode
Installation Mode is designed for users to dismount or remount the
siren without triggering a tamper alarm. Thus not to disturb other
people.
[Disarm ]
①
Press
button on the remote control continuously for
3 times, then the siren comes to installation mode after a long beep
is heard. Any sensor or tamper triggered during installation mode
will not result in siren hooting but 3 beeps will be heard instead.
Press
[Arm ]
button, the siren will exit from installation mode
②
after a long beep is heard. Or the siren will exit from connection
status when no operation is carried out within 10 minutes.
Note:
Also you can press the tamper switch 7 times to enter installation
mode.
Installation
Please finish all the system setup on the PCB and enter into
installation mode before installation.
Hold the positioning paper in right place, stick the gradienter on the
①
positioning paper to check and adjust the position.
After a wired sensor is connected
Install two screws into the top screw holes.
②
Mount the bracket into the bottom screw holes and tighten with
③
screws.
Tear off the positioning paper.
④
⑤
Mount the siren to the wall, tighten the screw and make sure the
siren is well positioned.
Gradienter
Positioning
paper
Enter Connection Status
Through Remote Control
This function is designed for users to connect newly-purchased
accessories without dismounting the siren from the wall.
When the siren is in installation mode, press
remote control continuously for 3 times, then the siren comes to
connection status after a long beep is heard, and then trigger the
new accessory once to complete the pairing.
The siren will exit from connection status when no operation is
carried out in 15 seconds.
EN
[Home Arm
]
on the
Werbung
Inhaltsverzeichnis
