Operation - Nowsonic DBOX two Bedienungsanleitung

DBOX TWO
GB
User manual

Operation

1) A DI box converts unbalanced sources like the signal of an electric
guitar or a keyboard into a balanced signal for connecting to any
microphone input of a mixing console or microphone preamplifier.
2) In addition, the impedance of the Hi-Z signal is adapted to the
low-impedance input of a subsequent microphone preamplifier.
3) Due to the design, you can connect either two monophonic sour-
ces (such as an electric guitar and a bass guitar) or a stereophonic
device (such as a stereo keyboard or a DJ mixer) to the DBox Two.
4) Depending on the configuration, you select the MONO or STEREO
mode via the corresponding switch: In STEREO mode, the signal
from INPUT 1 is routed to OUTPUT 1 and INPUT 2 is routed to OUT-
PUT 2. If MONO mode is active, the signal from INPUT 1 is routed
to both outputs: INPUT 2 then is not active.
5) The PHASE switch reverses the polarity of both channels; activate
the PHASE switch if you hear any phase cancellation with other
signals.
6) The HI CUT switch activates a low pass filter for damping signals
above 8 kHz. Activate the HI CUT to eliminate unwanted noise and
hiss or to damp the high frequency range (similar as a loudspeaker).
8) In order to obtain the best sound quality, please use only high-
quality cables. Please make sure that the cables are properly
connected.
9) Connect your audio sources (e.g. electrical guitar, bass, keyboard
etc.) to the sockets named INPUT 1 and INPUT 2.
Tip
In Phase (+)
7
www.nowsonic.com
Sleeve
Ground