Install The Battery - Motorola MTC100 TETRA PDA Bedienungsanleitung

Parts of your TETRA PDA
TETRA
Service LED
Antenna
Speaker
Camera *
Camera lens/flash
on the rear side
Display/ Touch
Contacts *
Power on/off
Home *
*) Programmable (typical use shown)

1 - Install the Battery

To install the battery remove the battery door by turning the circular latch
counter clockwise. Slide the battery into the battery compartment making
sure to first line up the top pin connections. Then push the bottom of the
battery gently into the compartment. Replace the battery door and tighten
the latch clockwise.
screen
Bottom connector
Pin connections
Power Status LED
W-LAN Signal LED
(if fitted)
Notes *
Navigation/ENTER
Calendar *
Tasks *
Microphone
3