Ibanez Prestige Bedienungsanleitung Seite 48

Adjusting the action
To adjust the height of the entire tremolo unit, use an Allen
wrench (4 mm) to turn the stud bolts located at the left and right
of the tremolo unit. (It is not possible to make adjustments for
each string individually.)
Adjusting the intonation
1.
Use an Allen wrench (3 mm) to loosen the pressure
pad bolts of the locking nut, and loosen the strings
suffi ciently.
2.
Use an Allen wrench (2 mm) to loosen the saddle
lock bolts, and adjust the saddle position.
Before checking the intonation, fi rmly tighten the saddle lock
※
bolts and tune the guitar correctly. When you've fi nished
making adjustments, tighten the saddle lock bolts and the
pressure pad bolts of the locking nut.
Replacing the strings
1.
Use an Allen wrench (3 mm) to loosen the pressure pad
bolts of the locking nut, and remove the string from the
tuning peg.
2.
Use an Allen wrench (3 mm) to loosen the string stopper
bolt of the tremolo unit; then pull the string out of the saddle
and remove it.
3.
Use wire cutters to cut off the ball end of the new string.
4.
Insert the tip of the string from which you cut off the ball end
between the saddle and the string holder block, and tighten
the string stopper bolt to fasten the string.
5.
Wind the string onto the tuning peg, and tune it.
6.
When you've fi nished tuning, tighten the pressure pad bolts
of the locking nut.
EN
47
➤➤