Initial Setup; If You Want To Reset This Feature; Using The Tv Controller - Samsung 5 series Bedienungsanleitung

04 Initial Setup

The initial setup dialogue box appears when the TV is first activated. Follow the on-screen instructions to finish the
initial setup process. You can manually perform this process at a later time in the MENUm → System → Setup menu.
• If you connect any device to HDMI1 before starting the installation, the Channel Source will be changed to Set-
top box automatically.
• If you do not want to select Set-top box, please select Aerial.

If You Want to Reset This Feature...

Select System → Setup (Initial Setup). Enter your 4 digit PIN number. The default PIN number is "0-0-0-0". (France:
"1-1-1-1")
If you want to change the PIN number, use the Change PIN function.
You should do Setup (MENUm → System) again at home even though you did in shop already.
• If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode, which
resets the PIN to "0-0-0-0": MUTE → 8 → 2 → 4 → POWER (on)

Using the TV Controller

You can turn on the TV with the TV Controller button at the bottom of the TV, and then use the Control menu. The
Control menu appears when the TV Controller is pressed while the TV is On. For more information about its usage,
refer to the figure below.
Control menu
: Power off : Volume Up
: Channel Up : Volume Down
: Channel Down : Source
TV Controller / Remote control sensor
Press: Move
Press & Hold: Select
The TV Controller is placed at the bottom
of the TV.
English - 13