Fisher Scientific FB3000-2 Handbuch Seite 13

Select a constant mode of operation by pressing the
appropriate function key located to the right of the display.
To switch between volts/current/power and time/volt-
hours/temperature, press function key F1. To change a
parameter, press the function key located to the right of
the display, next to the parameter you wish to change.
The FB3000 will allow a new value to be entered using
the keypad numeric keys. Press the function key labeled
"Enter" to complete the new setting. Press Clear to erase
previous keystrokes. Press Exit to cancel entering a new
value. The FB3000 will not accept any parameter outside
of the allowed range. Press Clear to re-enter an appropri-
ate value. When all the parameters of the step are as
desired, press Exit to return to the step screen. The
newly entered parameters will be displayed in the select-
ed step. To add a step after the selected step press the
function key labeled ADD. Enter parameters for the step
as for EDIT, pressing Exit when complete.
To delete a program or step, press the Clear key from the
program or step screen as desired. After confirmation the
FB3000 will remove the selected program or step from
memory.
Method number
Method 1
2 steps
Number of
steps
Figure 2. Program screen
Method number
Method 1 - 1/2
100V / 200mA
150W / 0°C
0:10
Step parameters:
the setpoint is
reverse video
Figure 3. Step screen
O
PERATION
Next
Navigation and
Prev
editing keys
Edit
Step 1 of 2
Next
Prev
Navigation and
Add
editing keys
Edit
13