Geneeo U-BOAT Anleitung Seite 6

Turing on your Speaker:
Slide the power switch to the "ON" position to turn the Spe-
aker on, and "OFF" to turn the Speaker off.
When the speaker is powered on, you should hear the no-
tice sound.
Wireless BT Pairing:
Your speaker can sync wirelessly with most Wireless BT
enabled devices and will remember the last 8 wireless con-
nections. The Speaker is capable of being paired with two
devices simultaneously, though audio can only be played
from one device at a time.
Connecting with Wireless BT:
Make sure that the speaker is turned on.
Turn on Wireless BT on your Wireless BT device and place
in pairing mode (check your device's manual to find out
how to sync your device through Wireless BT).
Once your Speaker is on, it automatically enters pairing
mode. Select the H2 from the list of discovered devices on
your Wireless BT device. Wait for a few seconds until the
connection is completed.
Legal Information:
This device complies with part 15 of the FCC Rules, Ope-
ration is sub.
Ject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must
accept any interference received, including interference
that may cause undesired operation.
NFC:
NFC: Put the mobile phone which is with NFC function near
Wireless BT speaker's Logo area, then the Wireless BT is
easily connected. If it could not connect properly, please
check if the mobile phone's NFC function is on.
3