Bosch THP 2020 A Produktbeschreibung / Montageanleitung Seite 18

English
General Notes Regarding Printer
D The following information can be sent to the printer:
- Operating procedures at the control panel (e.g. daytime operation)
- Alarm and fault messages
- Plain text, if programmed for an element
D On every printout:
- The date and time is printed
- The most recent event is always at the top of the printout
D Entries stored in the event database can also be printed if the operator has the appropriate
operation authorization.
D Always ensure the printer cover panel is closed properly. If the device contact is opened, inco-
ming messages cannot be printed, even at a later date, since the printer does not have its own
message memory. In this case, the message only appears on the display of the control panel.
D If the supply of paper is nearing its end, this is indicated by a message on the display of the con-
trol panel. When this message appears, you still have enough paper on the roll to print approx.
200 lines of text.
Using Jumpers to Change the Printer Settings
D Jumpers BR2, BR3 and BR4 must not be inserted if connecting to the FPA-5000!
D Warning: Inserting jumper BR1 changes the font from Western to Cyrillic!
Use only the thermal printer paper specified by the manufacturer
(Bosch product ID 4.998.110.290, package with 5 rolls).
The paper roll can be changed while the system is in operation.
Changing the Paper Roll
1. Open the safety screws and remove the housing front panel.
2. Turn down the paper locking lever (see arrow).
3. Pull out the paper roll unit.
4. Tear off the paper before the last printed message, then hold the paper roll on the collecting
spool and remove the securing disk by pulling to the left. Remove the printed paper roll from
the collecting spool.
5. Lift the empty paper roll, taking care that the support pin does not fall out.
6. Remove the empty paper roll and slide a new paper roll onto the support pin.
7. Push the support pin with the new paper roll back between the metal clips.
8. Guide the paper behind the metal pin A and up behind the paper pressure roller B.
9. Pull out the paper up to the paper roll unit and secure the paper with at least one of the pins
of the securing disk. Always slide the securing pins accurately along the guide slots of the collec-
ting spool.
10. Let the collecting spool fall back into its original position and turn up the paper locking lever
(see arrow).
11. Close the housing front panel and secure with the safety screws.
12. If necessary, tension the paper by pressing the paper feed button.
THP 2020 A
⇒
11 / 32
18 / 32
4.998.137.295
⇒
10 / 32
BDL-4998154001 / A3
ST - FIR / PRM1 / deh
GB