Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IQ-MX40 Mk.2
Channel
1
2
3
4
1 (X reversed)
2 (X reversed)
3 (X reversed)
4 (X reversed)
1 (Y reversed)
2 (Y reversed)
3 (Y reversed)
4 (Y reversed)
1 (X & Y reversed)
2 (X & Y reversed)
3 (X & Y reversed)
4 (X & Y reversed)
The DMX system is a high-speed digital data system, which can transmit
all the information required for light dimmers, multi-motor lighting effects
etc. down a single cable. The IQ250 outputs a DMX signal when operating
from its own microphone, which can be used to synchronise other IQ250s.
There is no limit to the number of units that can be connected to the DMX
signal, but it is not recommended that the total cable length should exceed
250m. Each unit connected to the DMX signal is given an address, and it
compares this to the data being sent on the DMX cable, so it can
determine which data is addressed to it. It then uses this data to move a
motor or set a brightness level as required by the controller. As the DMX
system can transmit as much information as 512 analogue control wires
-Page 4-
DMX Start
Switches on
Address
(Other switches off)
1
None
5
4
9
8
13
8, 4
33
32
37
32, 4
41
32, 8
45
32, 8, 4
65
64
69
64, 4
73
64, 8
77
64, 8, 4
96
64, 32
101
64, 32, 4
105
64, 32, 8
109
64, 32, 8, 4
DMX.
© N.J.D. Electronics 1996
User Guide
Werbung
