Sanus CAFC01 Handbuch Seite 5

1 Install Fan
2 Plug in Fan
6901-002144 <00>
(CAPT01)
[01]
Mount CAFC01 fan [01] at any 1U location on the front
rack rails above a component that could overheat using
four 10-32 x ¾ in. screws (not included).
(CC)
[02]
Make sure the master power
switch of the CAPT01 SANUS
EcoSystem™ Multi-volt Power
Supply (CAPT01) is in the
off position. Plug one end
of the power cord [02] into
the CAFC01's [01] jack and
the other end into one of the
CAPT01's 12 Volt power jacks:
 If the fan is to operate
continuously, plug the
power cord into one of the
"ALWAYS ON" jacks of the
CAPT01.
 If the fan is to be controlled
by the thermostat, plug
the power cord into one
of the "THERMOSTAT
CONTROLLED" jacks of the
CAPT01.
Power cord [02] may be
routed through the cable
channel (CC) included with the
CAPT01.
Refer to the instructions for the
CAPT01 for more information
regarding powering the fan.
[01]
1U
5