Herunterladen Diese Seite drucken

SELF Electronics SLT100-24VFC-UN Bedienungsanleitung

Led netzteil
Verfügbare Sprachen

Verfügbare Sprachen

Instruction for the use of
the LED POWER SUPPLY
Model: SLT100-24VFC-UN
Applications
This type of power supply is an exclusively designed stabilized
power supply for LED lamp. With constant voltage (CV)
technology, it is suitable for constant voltage lamps(24V)
The built-in protection circuit will shut down the power supply
in case of such faults as: open circuit, short circuit, over load or
over temperature. The power supply will restart automatically
after fault correction.
Important information for the installation
· The unit uses dangerous mains voltage(120-240VAC), it
should only be installed by qualified electricians according to
European safety standards or relevant nation regulations.
Failure to observe any of the installation instructions may
cause fire or other hazards.
·The power supply is for LED lamps only. Pay attention to the
polarity of LED, wrong polarity may damage the LED.
· The power supply is only for indoor use and permissible
operating temperature is -20 to 50℃.
·With cable clamp, the power supply can be independent
installed.
·The indicated load should not be exceeded.
SELF Electronics Co.,Ltd.
No. 1345 JuXian Road, Ningbo Hi Tech Park, Ningbo, China
·The maximum length of the output cable to the LED lamps
should not exceed 2m in order to meet the EMC standard.
·If the LED power supply is used for purposes other than
originally intended or it is connected incorrectly, the
manufacturer is not responsible for possible damages.
·The external flexible cable or cord of this product cannot be
replaced, if the cord is damaged, the product shall be
destroyed.
·Any controller base on Pulse Width Modulation (PWM)
technology connected to output side, need to be concerned
about the frequency of controller, the frequency is from 200Hz
to 5000Hz.
Specifications
Input voltage :
120-240Vac
Input frequency :
50/60Hz
Input current :
Input power factor :
Constant output voltage : 24VDC
Output current :
Rated output power :
Ambient temperature :
Case temperature :
IP protection :
Primary cable :
SJOW 17AWG (H05RN-F 3*1.0mm² )
Secondary cable :
SJOW 17AWG (H05RN-F 2*1.0mm² )
0.7A@120Vac,0.6A@220-240Vac
0.95 @120Vac
0.95 @220-240Vac
0-3.125A@ 120Vac
0-4.17A@ 220-240Vac
0-75W@ 120Vac
0-100W@ 220-240Vac
-20-50℃
75℃
IP66/IP67
loading

Inhaltszusammenfassung für SELF Electronics SLT100-24VFC-UN

  • Seite 2 ·Die angegebene Leistung sollte nicht überschritten werden. NETZTEIL ·Wenn das LED Netzteil für andere als die ursprünglich vorgesehenen Zweck verwendet wird oder falsch Modell: SLT100-24VFC-UN angeschlossen ist, übernimmt Hersteller keine Verantwortung für mögliche Schäden. Anwendung ·Elektronische Altgeräte sind Wertstoffe und gehören nicht in den Hausmüll.