Hama 00054221 Kurzanleitung Seite 10

6. Digitising records
Note - Storage medium
• The storage medium must be formatted using the
FAT32 file system.
• The recording is saved on the storage medium as an
mp3 file with a bit rate of 128kB/s.
• Always connect only one storage medium for
saving the recording. It is recognised by the device
automatically.
• Do not use a USB cable to connect USB volumes to
the USB interface. The USB port is intended only for
directly connecting USB storage devices.
• Switch on the record player as described in section 5.2
Switching on/off.
• Press [MODE] (17) repeatedly until the display shows
"PH". The device is now in playback mode.
• Place a record on the turntable.
• If necessary, place the 45 rpm adapter on the turntable
as described in section 4.7 Attaching the 45 rpm
adapter.
• Select the correct rotation speed using the rotation
speed control [33 SPEED/45 SPEED] (8).
• Insert an USB stick into the record player's USB port
(18).
• Alternatively, insert an SD/MMC card into the record
player's SD card slot (19).
• Wait until the record player has recognised the storage
medium. "LOD" appears on the display.
• Press [REC] (11) to start the recording.
• Move the tone arm to the desired place on the record.
The turntable starts turning automatically.
• During the record, [USB/SD] appears on the display.
• Press [ ] (13) to stop recording.
• After the recording is stopped, playback of the stored
audio file begins automatically.
6
7. Audio playback from a storage medium
Note - Storage medium
• The storage medium must be formatted using the
FAT32 file system.
• The storage medium is recognised by the device
automatically.
• Do not use a USB cable to connect USB volumes to
the USB interface. The USB port is intended only for
directly connecting USB storage devices.
• Switch on the record player as described in section 5.2
Switching on/off.
• Press [MODE] (17) repeatedly until USB is displayed. The
device is now in playback mode.
• Insert an USB stick into the record player's USB port
(18).
• Alternatively, insert an SD/MMC card into the record
player's SD card slot (19).
• Wait until the record player has recognised the storage
medium. "LOD" appears on the display. In this case,
"SD" lights up on the display.
• The record player automatically begins playback of the
audio files.
8. Care and Maintenance
• Only clean this product with a slightly damp, lint-free
cloth and do not use aggressive cleaning agents.
• Carefully clean the stylus with a cleaning brush.
• If you do not use the product for a long time, turn off
the device and disconnect it from the power supply.
Store it in a clean, dry place out of direct sunlight.
9. Warranty Disclaimer
Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
10. Service and Support
Please contact Hama Product Consulting if you have any
questions about this product.
Hotline: +49 9091 502-115 (German/English)
Further support information can be found here:
www.hama.com