Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TIGHTEN Bolts.
REAR INSTALLATION:
If You Have Doors...Open Them!
Repeat Steps 1 through 9
for the rear Crossbar.
• Consider the distance needed between front & rear Crossbars
(to accommodate your rack accessories).
WARNING:
• Do not re-install your rack
system on any vehicle other than
the one for which it is intended.
• Car door should close without
interference. If contact occurs,
loosen bolts and adjust towers.
Keep towers vertical.
HANDWHEELS:
Screw the
HandWheels
straight into
the threaded holes
in the towers.
Tighten firmly:
DO NOT
OVER TIGHTEN.
Check Your Rack!
• Grab each Crossbar end.
• Pull side to side.
• If anything moves, loosen
HandWheels & Bolts and readjust.
BE SURE ALL HARDWARE IS
SECURE BEFORE DRIVING AWAY!
WHEN TIGHTENING:
Gold
Do Not Let Towers
Pillar Screw
Lean into Roof.
must be in all
the way for
If this occurs:
complete turning.
•Loosen HandWheels,
and Bolts.
•Pull Towers outward.
•Tighten Bolts and
HandWheels.
LOCKABILITY:
Lock Cores are optional.
If you have
purchased
®
SKS
Lock Cores,
install them now.
Follow directions
that came with
Lock Cores.
CONGRATULATIONS!
HandWheels
must be
HORIZONTAL
during installation.
Enjoy your favorite adventure made
convenient by your durable Yakima Rack!
Werbung
