The Remote Control System; Charging The Battery - XciteRC EagleMT 30507000 Bedienungsanleitung

The remote control system

Here you get an overview of the remote control system of your Eagle Monster-Truck and its various features
and settings. Before the first flight, you should have read and understood all these functions and settings.
EN
• Make sure that the transmitter is turned off - ON / OFF switch in position O.
• Now open the battery compartment cover on the bot-
tom of the transmitter and insert two AA batteries (or
rechargeable batteries) into the battery compartment of
the transmitter. Pay attention to the correct polarity!
• Close the battery compartment cover and turn on trans-
mitter – push ON / OFF switch in position I - the red
transmitter POWER-LED starts flashing.
• Now switch on the model, the red LED must lit.
• WARNING: If the LED still flashes or goes out, the
model may not be started, because there is no binding to the model or the transmitter batteries are empty
– crash hazard! Change transmitter batteries immediately.
• Pay attention to the LED also during operation. If the LED flashes, stop driving as soon as possible and
replace transmitter batteries (or recharge the batteries).

Charging the battery:

Before the first use of your new model the drive battery needs to be charged with the included USB-charger.
WARNING: Charge may occur only with the supplied charger on a fireproof surface and under cons-
tant adult supervision - fire or explosion hazard!
For charging remove the battery from the vehicle.
WARNING: Make sure to read all safety instructions regarding the use of rechargeable batteries. Also,
if necessary, further safety instructions in the manual for your used charger.
• Insert the USB connector of the charger in a suitable USB socket, for example your PC. The green LED
lights up.
• Now connect the white balancer connector of drive battery to the jack of the Micro-Charger.
NING: the connector is polarized, note the bumps. The connector must engage with slight pressure, you
not use any force - fire hazard!
• If the battery is connected with the Micro-Charger, the LED changes from green to red, which indicates
that the battery is charged. The charging time is approx. 1.5 hours.
• The green LED indicates the end of the charging process, disconnect the battery from the charger.
• Unplug the AC adapter.
18
The remote control system · Charging the battery
1
USB
LED
5 V DC
2
-
+
WAR-
Eagle Monster-Truck