Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User Manual
IR Extender
Remote Control
The included remote control has 8 buttons that recall an associated
preset allowing the user to quickly change the screen layout.
Installation
Please note: This is a Quick Installation Guide which includes basic information only. All the configuration settings
and function controls of this system can be accessed through the Web interface embedded in all the units. Please
refer to the full manual published on the product's page (www.lindy.com) for further details.
Please follow the following steps to install the Video over IP Controller:
1. Please make sure that all the devices included in the installation are shut down
2. Connect, as required, the HDMI, USB (for keyboard and mouse or control devices only), Serial and Trigger
ports on the unit to the devices you want to attach to this system using standard cables.
3. Connect, as required, the IR extender cable to the IR EXT port
4. Connect a standard RJ45 Ethernet cable to the "LAN 2" port and to the network where the (No. 38266 and
38267) units are connected to. If you are connecting the units to a Gigabit PoE (IEEE 802.3af compliant) switch
you can skip step 6 and avoid using the supplied PSU.
5. Connect a standard RJ45 Ethernet cable to the "LAN 1 (PoE)" port to the network where the used control PC
to is connected to.
6. Connect (if required) the supplied PSU DC plug to the DC 5V ports
7. Turn on all the connected devices.
Now all the connections are made and the system is ready to be configured and distribute the managed signals.
Please refer to the full manual published on the product's page (www.lindy.com) to proceed with a detailed
.
configuration
IR Receiver cable for the connection with the IR Ext port
English
Werbung
