Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Calibration
1. Purchase a certified calibration solution that meets your requirements.
2. Disconnect the sensor from the union tee and dry.
3. Place the sensor in the calibration solution and keep the sensor
pins submerged.
4. Press the power button to turn on the TDS monitor. Check if each sensor
reading is correct by pressing the power button again to switch between
TDS sensors (S2 and S3 only). If the reading is not correct, follow the
steps below to perform the calibration.
5. Press the power button to select the TDS sensor required to be
calibrated (S2 and S3 only).
6. Press the power button twice quickly to enter calibration
7. Press the
or
8. Press the power button to complete calibration . The Digital Inline TDS
will automatically return to TDS measurement mode after 15 seconds.
*
The Digital Inline TDS can be reset to factory settings by pressing
the
and
button at the same time after step 6. All sensors will
be reset at the same time.
**
Each sensor has to be calibrated separately.
Notice
1. Avoid touching the sensor pins, as oils from skin may affect the TDS
measurement.
2. Clean sensor pins with rubbing alcohol and let air dry.
button to adjust the reading to the level of the solution.
2
English
mode.*
**
Werbung
