Technical Data; Proper Use; Maintenance And Cleaning - VOLTOTHERM QH 1800 Bedienungsanleitung

Anleitung QH 1800_SPK7:Anleitung QHT 1500_
To mount on a wall, please use the supplied wall
bracket.
Drill the three holes (1) such that the legs (2) of
the wall bracket are vertical.
Slide the plastic housing of the heater onto the
wall bracket from the top and as far as the stop. In
doing so, the legs (2) of the wall bracket are
pushed into the slots (3) in the plastic housing.

4. Technical data:

Rated voltage:
Output: 1800 W (600 W / 1200 W / 1800 W)
Protection type:
Mains lead:

5. Proper use

Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
6. Starting up
Important! Before using the appliance for the first
time, check that the voltage supply is the same as
the voltage details set out on the data plate.
Read the safety instructions listed in section 1.
The quartz radiant heater warms objects or persons
at which it is pointed but does not directly heat the
room air in the process. The heat output is set by a
switch with pull cord. The selected setting is
displayed.
6.1 Setting the heat output (Fig. 1):
The heat output is set by pulling the cord of the pull
switch (3) once or repeatedly. The selected heat
output can be read off the display (2). If the
maximum heat output is selected and the pull switch
is activated once more, the appliance shuts down.
6.2 Display of heat settings
No heat output = Display indicates "0", no heating
elements activated
Minimum heat output = Display indicates "1", one
heating element activated
Medium heat output = Display indicates "2", two
25.06.2007
heating elements activated
Maximum heat output = Display indicates "3", three
heating elements activated

7. Maintenance and cleaning

Maintenance and repair work may only be carried
out by an electrical servicing contractor.
Check the mains lead at regular intervals for signs
of defects or damage. A damaged mains lead may
only be replaced by an electrician in compliance
230 V ~ 50 Hz with the relevant regulations.
Important: Disconnect the mains lead before
IP24 cleaning – danger of electric shock.
3 x 1 mm 2 Use a damp cloth to clean the casing.
Never use combustible cleaning agents.
To remove dust on the reflector and heating
elements, use a brush with long soft bristles.
In cases of very stubborn dirt the appliance should
be cleaned by a professional.
15:47 Uhr Seite 7
GB
7