Installation - EuroLite FLS-6 Bedienungsanleitung

This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
This luminaire must never be covered. Danger of burning!
The F-symbol means: this device can be installed on normal inflammable surfaces.
- - -m
The symbol determines the minimum distance from lighted objects. The minimum distance
between light-output and the illuminated surface must be more than the given value.
The maximum ambient temperature T = 45° C must never be exceeded.
a
Do not shake the device. Avoid brute force when installing or operating the device.
When choosing the installation-spot, please make sure that the device is not exposed to extreme heat,
moisture or dust. There should not be any cables lying around. You endanger your own and the safety of
others!
This device must never be operated or stockpiled in sourroundings where splash water, rain, moisture or fog
may harm the device. Moisture or very high humidity can reduce the insulation and lead to mortal electrical
shocks.
The ambient temperature must always be between -25° C and +45° C. Keep away from direct insulation
(particularly in cars) and heaters.
The maximum relative humidity is 100 % with an ambient temperature of 25° C.
This device must only be operated in an altitude between -20 and 2000 m over NN.
Never use the device during thunderstorms. Over voltage could destroy the device. Always disconnect the
device during thunderstorms.
Never use solvents or aggressive detergents in order to clean the device! Rather use a soft and damp cloth.
Please use the original packaging if the device is to be transported. Make sure that you pack the device in
the original state.
Please consider that unauthorized modifications on the device are forbidden due to safety reasons!
If this device will be operated in any way different to the one described in this manual, the product may suffer
damages and the guarantee becomes void. Furthermore, any other operation may lead to dangers like short-
circuit, burns, electric shock, crash etc.

INSTALLATION

Unpack the LED FLS-6 Beam-Light and place on a flat surface.
Adjust the desired inclination-angle and tighten the fixation screw.
Carry the LED FLS-6 Beam-Light via the comfortable handle to the desired place for use.
9/10 00021399.DOC, Version 1.0