Usage - Aquapur AFR 3 C2 Bedienungsanleitung

Usage

NOTE
► This lint remover can damage structured fabrics
or very soft materials such as angora. Therefore,
always test the lint remover on an inconspicuous
part of the garment and turn the transparent part
of the spacer
then push the On/Off switch/Speed switch
speed level 1. The appliance now runs at speed
level 1. In this way you can gently test whether
the setting is sufficient for the garment without
damaging it.
► This appliance should not be brought into con-
tact with moisture. Therefore, do not use the lint
remover on moist fabrics.
1) Lay the garment on a flat surface, such as an
ironing board. Ensure that the surface to be pro-
cessed has no wrinkles. Otherwise, the garment
could be damaged.
2) Turn the spacer
remove it completely (see Chapter "Removing/
replacing the spacer"):
–
"Thick" for large bobbles and coarse textiles
(large distance to the cutter knives)
–
"Thin" for small lint/bobbles and fine textiles
(small distance to the cutter knives)
–
Remove the spacer
(virtually no spacing to the cutter knives).
│ GB │ IE
■ 20
first to the level "Thick" and
to the desired position or
, only for very fine lint
to
AFR 3 C2