Intended Use; Transportation And Storage; Safety Instructions - Kathrein UFOcompact plus Anleitung

Intended Use

The base unit UFG 810 is used for the accommodation and operation of headend modules
and channel units from the UFOcompact plus and UFOcompact range of products. A channel
unit adapter of the UFZ 800 type is required for the operation of UFOcompact channel units.
The UFG 810 provides infrastructure for ten modules of channel units. The base unit is
equipped with the UFN 800 power supply unit and the UFX 800 control unit ex works. As an
option, it is possible to insert the UVO 830 amplifier at the specified location.
The UFG 810 is actively ventilated, remotely controlled over an IP connection, cascadable and
redundancy-capable due to the UFZ 810 cable. The latter is used to connect two base units,
the power supply units of which automatically switch to the half-load parallel operation.
All components of the UFG 810 are intended exclusively for the application in the
UFG 810 as well as in satellite, cable or antenna reception systems. Any other use of fail-
ure to comply with these instructions will result in voiding of the guarantee or warranty.

Transportation and Storage

► Transport and storage the unit in its original packaging.
► Protect the unit against dust, dirt, moisture and direct sunlight.
► Transport and store the unit in the permissible temperature range from –25 to +70 °C.
Make sure there is no water condensation bildup.

Safety Instructions

WARNING
Hot surfaces!
During normal operation and increased ambient temperature, the surface
temperature may exceed 60 °C. Should thermal cut-out occur, there is
danger due to hot metal parts.
► Do not touch!
WARNING
Current-carrying device!
► Do not open or tamper with the device.
► When working on the system always unplug the power supply unit from
the wall socket.
► Ensure adequate clearance of at least 5 cm to all sides.
► Do not mount the unit overhead.
► Free circulation of air must be possible to discharge the heat emitted by
the unit. Danger of overheating!
► Bear in mind that the only reliable method of disconnecting the UFG 810
power supply from the mains is to unplug it.
► Connect the module carrier to the wall outlet with a protective earthing.
► Make sure that the mains plug are easily accessible and operable.
2 / 8